TQ6 Free Driver Download For Not Applicable

Get a GoFlight GF-TQ6 throttle quadrant

If anybody is considering about buying the MCP Pro and/or the TQ6 throttle quandrant, do your self a favour and get them. The gf-tq6 throttle quadrant standard shipping configuration consists of (4) jet thrust levers, (4) thrust reverse levers, a spoiler lever, and a flap handle.

The levers on the TQ6 have been backwards and forwards like an over utilized rocking chair, and the buttons and dials on the RP-48 have had more pushes and turns. Those who skilled a number of throttle units in the past, particularly Thurstmaster and CH Products, will discover TQ6 as by far the most complicated but also the most adaptable.

The connection of the GoFlight GF-TQ6 is by way of a standard USB cable but in order to configure the throttle quadrant you need to set up GoFlight's own configuration plan. The GF-TQ6 Throttle Console from GoFlight is designed as either a stand-alone unit for the desktop or as a standard 4 inch rack-mounted GoFlight module.

Here the GoFlight GF-TQ6 throttle quadrant is setup using the optional lever set to match the arrangement found in a typical contemporary twin.

Clearly compared to the CH products throttle quadrant, the GoFlight GF-TQ6 is a serious piece of metal hardware so you ought to expect that some controls be a small bit more stiff to move.

The only devices from GoFlight that will be recognised as individual controllers in CoD are the following: GF-TQ6 (throttle quadrant), GF-TPM(throttle-Prop-Mix) and the GF-Rudder pedals (discontinued) maybe an additional with axes controls.

The TQ6 really has six levers which are connected to a pot-meter and four axis that are dummy axis. These four axes 'share' the exact same 'opening' in the TQ6 where the four actual pot-metered axis goflight tq6 reside, which means, you can moven them like an axis. Nevertheless, they do not have any pot-meter attached to those axis.

The game controller interface is discovered within the operating systems manage panel, and once the TQ6 is plugged in and recognized, it shows along with any other controllers you may have installed. The GF-TQ6-ADV Throttle Quadrant standard configuration includes two Boeing 737 jet thrust levers with two connected thrust reverse levers, a spoiler lever, and a flap handle.

The default calibration of the TQ6 should be a reasonable guess, but you can go to File/Setup and change the default values for minimum lever position, maximum lever position, and jitter suppression.

It might take a couple of flights for flight hobbyists with it before starting to get some command of the big plane but the GF-TQ6 will give the feeling of flying a large jet...grabbing a hand full of throttle levers and shoving all 4 of them forward for takeoff is quite a rush.

The GF-TQ6 is great fun to use and considerably adds to the realism of flying multi-engine aircraft. Use it for a couple of hours of enjoyable flying and with a quantity of different aircraft, such as the default 747-400, King Air and DC-three. Maybe the lever colors don't match, but the GF-TQ6 was effortlessly setup to match the DC-3's lever arrangement.